|
|
Post by Shan Simpson on Feb 1, 2007 23:05:22 GMT -5
Does anyone know what the key code is for a 62 my bus doesn't have original keys (surprise surprise) and I'm looking into getting some
|
|
|
|
Post by commercialair on Feb 1, 2007 23:12:49 GMT -5
Does it have the original ignition or handles?? I'm not sure what the blank number would be, but you can pull the codes directly off the handles. Gabe should be able to help you out. Also, we have a great old locksmith here that has alot of blanks. With an original key from Keith (thanks again buddy) he rekeyed all my locks and ignition to match for about 50 bucks, with an extra key.
If you want to send them to Regina, I can set you up.
Chris
|
|
|
|
Post by bullyboy on Feb 3, 2007 19:24:05 GMT -5
I did the same with the local locksmith and he looked it up on the computer and spit one out for my 61' in a couple minutes. I have one key for door, ignition and engine lid lock  |
|
|
|
Post by Milkman on Feb 3, 2007 19:36:50 GMT -5
Where would you find the code on the ignition cylinder? I have a correct cylinder for my Kombi now, but no key for it. So if I can find the code on my door handle I should be able to get the cylinder coded to match?
|
|
|
|
Post by bullyboy on Feb 3, 2007 23:42:51 GMT -5
You can't change the ignition, just the door tumblers. The ignition key # is located at the tip of the mounting tab next to the screw hole. On the handle its the bottom side below the keyhole. Usually SE SH or something with 2 numbers after. You can check out Gabriels site for all the different series of keys. www.gabrielsvwgarage.com/ |
|
